Questions tagged [dhcp]
DHCP is an auto configuration protocol used on IP networks.
729 questions
0
votes
0
answers
53
views
Sharing internet connection between 2 pc
I have 2 ubuntu PC connected together by an ethernet cable.
My PC 1 have internet access through another internet cable. My PC 1 also host a DHCP server to give an IP address to my PC 2, because my PC ...
- 1
0
votes
0
answers
30
views
Networkmanager shared wired connection no DHCP in hairpin mode
I'm setting up a Raspberry Pi as a mini router for university Accommodation, using NetworkManager to configure the connections, but I'm running into a problem.
My current setup has a USB ethernet ...
- 31
0
votes
0
answers
42
views
Fedora 36 NetworkManager delete old IP, DHCP addresses from adapter enp0s3
I am trying to remove an old IP and route from Fedora 36 NetworkManager. I recall my steps as I followed them. I am using Win-11 x86_64(host), VirtualBox 6.1.5, Fedora 36 (guest.) When I installed the ...
1
vote
1
answer
33
views
How to allow local network dotless names using Network Manager in Linux Mint with DHCP?
I have two hosts, MintPC and AlpineVM. The VM is on a bridged network so it appears as its own device on the network with its own address. Both obtain addresses through DHCP provided by my router/...
- 11
0
votes
0
answers
46
views
dnsmasq '--read-ethers' and '--address' interaction
I run dnsmasq on a server (specifically OpenWrt) to act as both DHCP and DNS.
OpenWrt DHCP configuration /etc/config/dhcp:
option readethers '1'
list address '/my-phone.lan/172.28.79.133'
Which is ...
- 455
1
vote
1
answer
77
views
Client PC (with DHCP assigned IP) cannnot get the Internet
I have one computer, Server, with two Ethernet ports, enp2s0 and enp3s0.
What I want to do is that I want this computer to connect to the internet via company network (10.11.1.0/24) and also be a DHCP ...
- 87
0
votes
1
answer
174
views
PXE reading the file name incorrectly
I’m setting up a PXE boot environment using a DHCP server and a Realtek RTL8168 NIC (bulit-in ethernet on my mainboard). I’ve configured DHCP Option 67 to send the boot file name (netboot.xyz.efi), ...
- 1
0
votes
0
answers
34
views
Reboot required after losing network on Linux 21.3 on a HP Pavilion on NowTV Model NR801 router
I'm running Linux 21.3 on a HP Pavilion.
If lose wifi connection due to poor signal to my NowTV Model NR801 router, I'm unable to reconnect to any network (including wired) without rebooting my ...
Dave Russell
0
votes
2
answers
381
views
Why can't ifupdown find dhcpcd?
So I have an embedded system I've built with yocto. I'm trying to enable DHCPv6. But when I try to bring the interface online, ifup says it can't find DHCPv6 software, even though dhcpcd is ...
- 45
1
vote
2
answers
246
views
Pop!_OS slow kernel boot time when ethernet cable not connected
I am running Pop!_OS 22.04 LTS on my laptop, which is based on Ubuntu 22.04 LTS.
Linux is set up with root partition encryption, with auto-decryption set up during boot since I am only using the ...
0
votes
1
answer
158
views
Alpine Kea dhcp server deny unknown-clients
I checked the whole conf file but did not find the option equivalent to "deny unknown-clients" of Debian isc-dhcp-server.
Possible?
- 109
1
vote
1
answer
389
views
Getting systemd-networkd to honor [DHCPv4] FallbackLeaseLifetimeSec option
Related to this question
How do you get systemd-networkd to honor the [DHCPv4] setting FallbackLeaseLifetimeSec=forever? (Or more probably, what am I doing wrong that is preventing this?)
When it ...
- 183
-1
votes
2
answers
116
views
Internet on USB to Ethernet adapter in a multi port Linux PC
Linux version : Ubuntu 22.04 server minimal
This box has 3 NIC cards and all those three NIC cards will be configured with static addresses by configuring in file /etc/netplan/00-installer-config.yaml ...
0
votes
0
answers
35
views
How to access IP and port configuration of the tablet running Linuxmint with "hostapd + DHCP"
My task: Configure and run Access Point (AP) on the tablet (x86) with Linux mint with access from devices connected to the created AP.
Background as additional information (but this is not the topic ...
- 101
1
vote
1
answer
239
views
Configure Debian to connect to ONT like IPoE/DHCP router provided by the ISP
My ISP provides a pre-configured Asus router running Linaro GCC 4.6-2012.02 which connects to ONT (fibre box) via Ethernet cable. I can SSH into the router and see the WAN interface:
18: vlan10@eth0: &...
- 469