This guide shows how to turn just about any box with a lid into a customizable music box.
This music box begins playing music as soon as it's opened, and the user is greeted with a dancing figure (for this project, rather than a slowly turning ballerina, an Adabot takes center stage). When closed, the singing and dancing automatically shuts off.
Circuit Playground Express is the next step towards a perfect introduction to electronics and programming. We've taken the original Circuit Playground Classic and...
guides with product
Out of Stock
Sometimes we wonder if robotics engineers ever watch movies. If they did, they'd know that making robots into servants always ends up in a robot rebellion. Why even go down that...
guides with product
$29.95
In Stock
This here is your standard A to micro-B USB cable, for USB 1.1 or 2.0. Perfect for connecting a PC to your Metro, Feather, Raspberry Pi or other dev-board or...
$2.95
In Stock
Tiny little servo can rotate approximately 180 degrees (90 in each direction) and works just like the standard kinds you're used to but smaller. You can use any servo...
$5.95
In Stock
Your eyes do not deceive you – this is absolutely an AdaBot lunchbox! Whether you're sporting this at school, work, Maker Faire, or jury duty, this...
guides with product
$9.95
In Stock
Hear the good news! This wee speaker is a great addition to any audio project where you need 8 ohm impedance and 1W or less of power. We particularly like...
$1.95
In Stock
Materials & Tools
To build this project you'll need:
- Box with lid (such as the AdaBot Lunchbox)
- Paper and a printer
- Hot glue gun and hot glue
- Scissors
- Scrap cardboard
- Double sided foam tape
Page last edited March 08, 2024
Text editor powered by tinymce.
