3D Print your own snap fit enclosure for the MagTag. This features a built-in kickstand that positions your MagTag at the perfect viewing angle.
The case accommodates all of the various ports and components such as the two 3-pin JST connectors, STEMMA QT port, light sensor, reset button, boot 0 button, and USB-C port.
The on/off switch is an additional piece that is bigger in size, making it easier to use. The four front facing buttons also have extra parts that feel great to press and more ergonomic.
The case has enough space to accommodate a 500mAh LiPoly battery for making the MagTag portable. Projects that feature deep sleep may allow the device to run for several days!
The Adafruit MagTag combines the ESP32-S2 wireless module and a 2.9" grayscale E-Ink display to make a low-power IoT display that can show data on its screen even when power is...
guides with product
$34.95
In Stock
Totaling 420 pieces, this M3 Screw Set is a must-have for your workstation. You'll have enough screws, nuts, and hex standoffs to fuel...
$16.95
In Stock
Got a glorious RGB Matrix project you want to mount and display in your workspace or home? If you have one of the matrix panels listed below, you'll need a pack of these...
$2.50
In Stock
Lithium-ion polymer (also known as 'lipo' or 'lipoly') batteries are thin, light, and powerful. The output ranges from 4.2V when completely charged to 3.7V. This...
$7.95
In Stock
Page last edited October 07, 2025
Text editor powered by tinymce.
