Questions tagged [qtouch]
The qtouch tag has no summary.
9 questions
0
votes
0
answers
104
views
Noise Issue on LM5164 Buck Converter Output During Battery Charging
I am using the LM5164QDDARQ1 buck converter to step down 52V from a lithium-ion battery to 5V at 1A for a battery charging application. My system also uses CAN communication to monitor the charging ...
0
votes
0
answers
98
views
Simulate capacitive touch sensitivity and noise immunity
Due to covid, we are limited in the time we can tune our touch designs before EMC tests.
The device we are using has a PC based analyzer that is connected to the device over a serial protocol. ...
- 1
0
votes
1
answer
163
views
Qtouch with non-Atmel microcontrollers
Simple question really. Can I use Atmels Qtouch library with non-Atmel MCUs (such as an STM32)?
It seems like Atmel has a solid line of capacitive touch ICs, ...
- 433
0
votes
0
answers
310
views
Why does my IR receiver PCB only work when I touch the sensor pins?
I have designed a PCB based on a schematic which I am pretty sure that is correct and I have tested the schematic several times on the breadboards and all of them worked properly.
But, after I ...
- 73
0
votes
1
answer
197
views
QT1070 inconsistent readings on touch pins
I recently transitioned my projects capacitive touch IC from using the MPR121 to the QT1070.
I am getting irregular/inconsistent readings on one of the touch pins. In this particular situation, it ...
- 433
2
votes
1
answer
188
views
AT42QT2160 capacitive touch controller inverted Cs voltage - no touch detected
I'm trying to make my own development board for the AT42QT2160 Touch controller, since the original one was discontinued. I've designed the PCB with 8 buttons and a slider consisting of 8 sections. It'...
- 41
0
votes
0
answers
103
views
QT600 Under Atmel Studio 7
Using the QT600 development kit under Studio 7 in order to develop a touch interface, I can not get the kit to show up when not in programmer mode.
I've managed to write the example HEX onto the ...
- 1,912
1
vote
1
answer
1k
views
Which MCU (Atmel) I can use with QTouch library?
Some MCU have QTouch support - # touch channels implemented as a hardware. Is it true that QTouch library was designed only to work with such MCUs? Can I use it with, for example, 'old' ATmega48? Is ...
- 366
1
vote
1
answer
1k
views
ATTiny45, LED strip, MOSFET, touch interface, but Vcc drops and tiny resets
I've developed a very little board with the ATTiny45 and mosfet (STD35NF06LT4 - http://www.farnell.com/datasheets/1689946.pdf ) to drive a high power LED strip at 24V.
I have a 5V dc/dc converter (...
- 21