1

I've connected to RS232 device with arduino. When showing data in arduino its showing as:

235
157
191
157
159
153
157
0

While in Hyperterminal it's showing as:

 101 102 103 104

How to get the same data as hyperterminal in arduino too?

My Arduino code:

   if (RS232.available()) {
    int incomingByte = RS232.read();

    Serial.println(incomingByte);

    //Sending to bluetooth
    BTserial.println(incomingByte);
  }
Improve this question
6
  • The Arduino serial monitor is incredibly crude and barely usable at the best of times. It may be to do with line endings, or something similar. Personally I would use putty or teraterm rather than hyperterminal, since that is a bit crude too (though not as crude as the arduino serial monitor). Commented May 11, 2017 at 16:03
  • @Majenko In my case, Hyperterminal is showing correct data as above. But serial should show similar data too. Is there any problem in my Arduino code? Commented May 11, 2017 at 16:50
  • Not in that little snippet, no. However the two serial programs do deal with line endings in a very different manner, which is probably where the difference in displays lies. Commented May 11, 2017 at 16:56
  • What results do you get if you change int incomingByte to char incomingByte or to byte incomingByte? Commented May 11, 2017 at 17:00
  • 1
    Rahul Rastogi, by “result remains the same” do you mean the same as for "char incomingByte", or like the “int incomingByte” output? Commented May 11, 2017 at 18:34

0

Reset to default

Start asking to get answers

Find the answer to your question by asking.

Ask question

Explore related questions

See similar questions with these tags.